The Continuous Weave Harness Setup Guide is available as a PDF    OMS_continuous.pdf   326kb
and is also available as a DOC  (images might be clearer than pdf)     OMS_continuous.doc   384kb

To save to disk, right mouse-click the link, select "save target as" or "save link as" to your hard drive (depending upon browser)

Copyright 2004 Sub-Aquatic Technologies / Doug Arnberg / www.sub-aquatic.com/

It’s sometimes hard to wrap your mind around assembling a one-piece continuous weave harness system. If you’ve never done one before or if it’s been a while and you simply need a refresher, this document can help. If you need more info, please email me.

doug@sub-aquatic.com

The OMS Continuous Weave Harness system (BP166) system Includes:

• 11 feet of 2" black webbing assembled with a SS grommet in the center(main harness). Length may vary slightly.

• 3.5 feet of 2" black webbing with a loop sewn at one end (crotch strap). Length may vary slightly.

• 6 SS D-rings

• 6 SS slides

• 1 SS quick release

We recommend using the OMS Al back plate (BP020) or SS back plate (BP015) (sold separately), depending on your needs. OMS back plates are superior in quality and provide smoother edges to promote a longer life to webbing and other gear that may come into contact with plate edges. Read more at http://omsdive.com/backplate-mfg.html

1. Start by inserting one end of the main harness webbing through the top slot (from the back towards the front of the back plate).

2. Continue pulling the webbing through until the grommet comes through followed by another 5" or so of webbing.

3.Continue by inserting the same end of webbing you’ve been working with through the lower slot; this time from front to back. Pull the entire length through to the back of the plate until the grommet and 5" of webbing following the grommet, are through.

4. Turn the plate around so you’re looking at the rear of the plate and insert the end of webbing you’ve been working with through the bottom slot on the opposite side of the plate. Adjust the webbing until the grommet is centered with the bolthole of the plate.

5. Insert the same end of webbing back up and through the top slot all the way as far as it will go and pull it tight (from front to back.).

6. This completes the upper most assembly of the harness. Be sure that the grommet is centered with the hole in the black plate and that the harness looks like the image below.